![]() But trying to access the device with my application will be aborted by error, it seems the system description still holds the error message. Right-click COM Port and select Properties. Expand the COM and LPT Ports Drop Down Section. Type devmgmt.msc in the search bar and hit Enter. If plugged in again it is possible to read the Windows Device Description by USBTreeView and the device is shown in the display without any error. 1 Answer Sorted by: 0 Upon further research it was found out that there is no need to install Virtual Com Port Driver (VCPV1.3.1Setup.exe) in windows 10 as usage of the native Inbox driver is recommended, for more information, read their technical documentation at. Proceed as follows: Open Device Manager by pressing Windows Key + R. So nothing happens File is arduplanewithbl. ![]() ![]() This error disappears in case of unplug and replug of the device USB connection. 12:54:04 USB device successfully opened with ID: 1 12:54:04 USB device successfully closed. The interface problem melts down to a corrupted USB Device Description for the STM-Driver with the windows error message ConfigDescriptor 1 Error : ERROR_CRC. STSW-LINK009 ST-LINK-v2 USB driver for Windows 7/8, Vista, and XP STSW-LINK006 ST-LINK-v2 USB driver for Windows 8. I am the first to use the board in conjunction with an FTDI-Controller and this is where the problems became severe.īy protocoling on both USB-Interfaces with some USB-Sniffer I can say that there is no direct interference on both channels in communication. STM32 ST-LINK Utility (STSW-LINK004) is a full-featured software interface for programming STM32 microcontrollers. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil, TASKING. 64bit and windows 7, to make sure Version 1.5.0 is installed though this one comes with a 1.3.1 in the driver details.Ībout the SW on the controller board, I don't have any idea but it's used in the house with a lot of different set up's working. Yes, did follow the instructions well, I made a deinstall with driver-SW-erase of the previous driver before installing the new driver with adequate attributes, i.e. STM32CubeMX is a graphical tool that allows a very easy configuration of STM32 microcontrollers and microprocessors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |